Automatic Hydraulic C Z Purlin Roll Forming Machine
With PLC Control System
Details of roll forming main machine
- Purlin specifications: width :80-350mm,height: 40-80mm,small rib: 14-25mm
- Coil thickness:1.2-3.5mm Q195~235, zinc coils & Hot Rolled coils
- Working speed: 10-25m/min (not containing punching and cutting time )
- Forming roller: 17steps
- Leveling roller:5steps (up 2 and down 3)
- Rectifying: one step
- Feeding & guiding: 2 sets ,4 rollers
- Material of roller: GCr15, quenched
- Material of main shaft:45﹟ steel
- Main motor: 15KW
- Feeding, leveling motor power: 7.5 KW
- Hydraulic pressure: 15-20MPa
- Hydraulic power: 7.5 KW
- Two servo motor and four encoder
- Transmission: Transmission by by Chains 1.2Inch double line
- Main dimension: 11000mm x 1400mm x 1400mm (L x W x H)
- Total weight: 14000kg
Standard of hydrauic decoiler and manual decoiler
- single head to put the coil hydraulic fiow over device
- coil spec:508*1300mm
- flow over range: 460-520mm
- oil cylinder:160*90mm
- drive by hydraulic brake
- Power of decoiler:4KW cycloid motor
- Dimensions: 1700mm*1000mm*800mm
- Width of feeding: 600mm
- Capability: 5 Ton
- Bound of expand &fight: 450mm—510mm
- Mode of expand &fight: inner expand &fight by manual
- Way of feeding: manual
PLC control system (panasonic)
- Voltage, Frequency, Phase: 415V, 50 Hz, 3Phase
- Automatic length measurement:
- Automatic quantity measurement
- Machine will automatically cut to length and stop when required quantity is achieved
- Length inaccuracy can be amended easily.
- Control panel: Button-type switch and touch screen
- Unit of length: millimeter (switched on the control panel)
- The program should be can set 5 different measure and quantity.
Details of punching and cutting
- Punching mold: Cr12 HRC 58-62
- Machine with 3 sets punching system
- Punching with hydraulic drive
- Punching in longitude wise controlled by PLC, punching at horizontal wise adjusted by manual hand wheel.
- Punch details as shown in drawing.
- Hydraulic Cutting before forming: Cut the sheet before roll forming to required length.
- Cutting motion: The main machine not stop and the continue punching and cutting.
- Material of blade: CR12with heat treatment
- Length measuring: Automatic length measuring
- Tolerance of length: 3m+/- 1.5mm
Manual out table
- Jointed by 60mm*40mm tube
- Size: 1.0m long*0.8mwide*0.6-1mhigh
- One out table with two support roller
CompositionS of machine
||Roll forming main machine
||Manual out table
Some pictures of machine
Introduction of company
We, Friendshachinery Co., Ltd, attaches great importance on technology innovation,progress has been made on scientific management as well as Co.,culture.Our manin products: Metal roof &wall panels machines, C&Z purlin machines drywall Stud-track forming machine,Metal decks machines,No- girder and Column curves forming machines,Guard rails forming machine,Downspout pipes forming machines and so on.
We can customize forming machine according to user's requirements.And we can provide professinal service,high quality,through design,and installation.
Warmly welcome to visit our factory no matter you are distibuters or end-users,and looking forward to cooperating with you for mutual benefits.
For more information, feel free to contact with us.